Range Rover Evoque: Conditions causing automatic engine restart

The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program are selected
- battery charge becomes low
- brake vacuum has been reduced (eg using the brake pedal repeatedly with the engine off)

READ NEXT:

 Disabling stop/start

Disabling stop/start To switch the system off (preventing automatic stop/start) press the ECO switch. The LED indicator will extinguish to confirm that the system is off. Note: The engine will

 Eco stall recovery

In the event that the engine stalls, it can be restarted by fully depressing the clutch pedal. Note: Automatic stall restart will only operate once. If the engine is stalled a second time the engi

 Emission control system

Land Rover vehicles are fitted with emission and evaporative control systems. In many countries it is unlawful to tamper, modify or replace such equipment and legal penalties apply if the laws are

SEE MORE:

 Changing a fuse

Always turn off the ignition system and the affected electrical circuit, before replacing a fuse. Fit Land Rover approved replacement fuses of the same rating and type, or fuses of matching specification. Using an incorrect fuse, may result in damage to the vehicle's electrical system and

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal and Installation). Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re

© 2011-2025 Copyright www.rrevoque.org