Range Rover Evoque: Glass Roof Panel Blind Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
All vehicles
1. NOTE: The step must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3-door
2. NOTE: The procedure must be carried out on both sides. Refer to: B-Pillar Upper Trim Panel - 5-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).
5-door
3. NOTE: The procedure must be carried out on both sides. Refer to: B-Pillar Upper Trim Panel - 5-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. NOTE: The procedure must be carried out on both sides. Refer to: C-Pillar Upper Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
All vehicles
5. NOTE: The procedure must be carried out on both sides. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
6. Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
7. NOTE: The step must be carried out on both sides.
8. NOTE: The step must be carried out on both sides.
9. NOTE: The step must be carried out on both sides.
10. NOTE: The step must be carried out on both sides.
11.
12.
13. NOTE: The step must be carried out on both sides.
14. NOTE: The step must be carried out on both sides.
15. NOTE: The step must be carried out on both sides.
16.
17. CAUTION: Do not use excessive force to release the headliner from the side retaining brackets.
NOTES:
Headliner shown removed for clarity.
Vehicles with glass roof panel only.
Release the headliner from the retaining brackets using a suitable plastic trim tool.
18. CAUTION: Extra care must be taken at this point, as the headliner is still retained by a locating clip at the rear and the 3 retaining clips at the front.
NOTE: This step requires the aid of another technician.
Lower the headliner for access.
19. NOTES:
Headliner shown removed for clarity.
This step requires the aid of another technician.
- Release the headliner from the 3 front retaining clips (1) and slide rear wards to detatch from the locating clip (2).
- Lower the headliner for access.
20. Torque: 3.5 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Rear Quarter Window Glass 5-Door
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: C-Pillar Upper Trim Panel (501-05 Interior Trim and
Ornamentation, Rem
Instrument Panel TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Descriptio
SEE MORE:
Front Side Member and Suspension Top Mount
Assembly
Removal
NOTES:
The front side member and suspension top mount assembly consists of the
front side member closing panel, fender apron panel front
reinforcement, fender apron lower panel, suspension top mount, and fender apron
panel reinforcement.
The front side member and suspension top mount is m
Wading
The maximum advisable wading depth is
500mm (19.7in). If the vehicle remains
stationary in water above the door sill level,
severe electrical damage may occur.
Do not switch off the engine when
wading and avoid stopping. If the
engine stalls, restart immediately.
If water has entered the en
