Range Rover Evoque: Parking aids

Parking aids
Parking aids

1. Parking aid on/off switch. The switch indicator will illuminate.

When reverse gear is selected, the front and rear parking sensors are activated automatically.

To turn off, press the button. The indicator will extinguish.

2. Approximate sensor range -600mm (24in).

3. Approximate sensor range -1500mm (60in).

responsibility It remains the driver’s responsibility to detect obstacles and estimate the vehicle’s distance from them. Some overhanging objects, barriers, chain link fences, small children, animals, thin obstructions or painted surfaces may not be detected by the system.

frequency Systems using the same frequency band as the front parking sensors, may cause irregular tones to be emitted.

Front sensors will remain active as long as the vehicle's speed does not exceed 16km/h (10mph).

With automatic transmission, selecting N from R will keep front and rear sensors active.

When objects are detected, the parking aid emits a warning tone which increases in frequency as the vehicle gets closer to the object and then becomes constant when the obstacle is within 300mm (12in).

Note: The front parking aid provides an audible proximity warning when driving forwards and when reversing.

READ NEXT:

 Towing

The rear sensors are automatically disabled when a trailer with an approved electrical connector is connected. Note: Trailers fitted with LED lights will not disable the rear parking aids sensors.

 Cleaning the sensors

When washing the vehicle do not aim high pressure water jets directly at the sensors. Do not use abrasive materials or hard/sharp objects to clean the sensors. Only use approved vehicle shampo

 System fault

If a system fault is detected, a long high-pitched tone will sound and the switch indicator will flash. A message will be displayed in the message centre. Contact your Dealer/ Authorised Repairer

SEE MORE:

 Differential Case Vehicles With: AWF21 6-Speed Automatic Transmission

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the LH rear wheel and tire. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installati

 Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension

Special Tool(s) JLR-204-804 Lever, Wheel Knuckle General Equipment Transmission jack Wooden Block CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. LH illustration shown, RH is similar. NOTES: Removal steps in this procedure may contain installation d

© 2011-2025 Copyright www.rrevoque.org