Range Rover Evoque: Replacing remote control batteries
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Heating and ventilation / Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.
READ NEXT:
Additional remote controls
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Driver/Passenger Seat Module (DSM/PSM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component
Front Seat Recliner Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
3. Refer to: Front Seat Co
© 2011-2025 Copyright www.rrevoque.org
