Range Rover Evoque: Speed Control
Speed Control Actuator
Removal
1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
Installation
1. To install, reverse the removal procedure.
Speed Control Deactivator Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: LH illustration shown, RH is similar.
2.
Installation
1. To install, reverse the removal procedure.
Speed Control Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the air bag supplemental restraint system (SRS) safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).
4. Torque: 1.3 Nm
5. CAUTION: Take extra care not to damage the edges of the component.
Torque: 2.1 Nm
6. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
SEE MORE:
Engine Oil Draining and Filling, Camshafts
Engine Oil Draining and Filling
Draining
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the engine undershield.
Refer to: Engine Undershield (501-02 Front End Body Panels
B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. CAUTION: Discard the bolt.
Torque: 45 Nm
5.
6.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
inst
