Range Rover Evoque: Tyre change

valve core Valve stem seal, washer, nut, valve core and cap should be replaced at every tyre change. Valve stem seal, washer and nut must be replaced if valve retention nut is loosened. Sensor units and nuts must be refitted using correct torque figures and associated profile. Damage to the vehicle may result if these precautions are not taken.

Any tyre changes must be carried out by a qualified technician. Great care must be taken during removal and refitting of tyres to avoid damaging the sensor.

READ NEXT:

 Replacement sensor

Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer. A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The v

 Tyre repair kit

 Tyre repair kit

If you are in any doubt regarding your ability to carry out the instructions, contact your Dealer/Approved Repairer before attempting the repair. Your vehicle may not be equipped with a spare

SEE MORE:

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High Speed CAN (controller area network) bus; N = Medium Speed CAN bus; O = LIN (local interconnect network) bus DW12C is shown, GTDi is similar Battery Blower motor LH (left-hand) temperature blend stepper motor Windshield distribution (defrost) stepp

 Differential Rear Bushing

Special Tool(s) 205-860-09 Installer, Differential Bushing 205-861-01 Remover, Differential Bushing 205-861-02 Remover/Installer, Differential Bushing 205-861-03 Installer, Differential Bushing 205-861-04 Installer, Differential Bushing 205-861-05 Installer, Differential Bushing LR-121 Hydraulic Cyl

© 2011-2025 Copyright www.rrevoque.org