Range Rover Evoque: Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions.

2. Pass the tether strap over the seat back and beneath the head restraint.

3. Attach the tether strap hook to the tether anchor point on the back of the seat.

Ensure that the tether strap hook is facing the correct way.

4. Tighten the tether strap according to the manufacturer's instructions.

READ NEXT:

 Airbag supplementary restraint system (SRS)

Airbag supplementary restraint system (SRS) 1. Front passenger’s airbag 2. Curtain airbags 3. Side airbags 4. Knee-bolster airbag 5. Driver’s airbag Note: The general location of airbags f

 Airbag operation

For the airbags to operate correctly the roof lining and door post trims must be in good condition, correctly fitted, and free from obstruction. Any damage, wear, or incorrect fitment should b

 Disabling the passenger airbag (not Australia)

Crash test data and statistics show that the safest place for a child to be restrained is in a child seat correctly fitted to the vehicle's rear seat. Do not use a child restraint on a seat pr

SEE MORE:

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Front Halfshaft LH (205-04 Front Drive Halfshafts, Removal and Installation). Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Fron

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CA

© 2011-2025 Copyright www.rrevoque.org