Range Rover Evoque: Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal.

If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity.

READ NEXT:

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

 Gear shift indicator

The gear shift indicator illuminates briefly at the recommended gear change point (upshift). The shift indicator will not illuminate while Cruise control is active and is not being overridden

SEE MORE:

 Water Drain Panel Section

Removal NOTE: The water drain panel section is manufactured from mild steel. 1. The water drain panel section is replaced in conjunction with: Rear bumper cover Tailgate Quarter panel Rear lamp mounting panel 2. For additional information relating to this repair procedure please see the foll

 Supplemental Restraint System (SRS) Health and Safety Precautions

WARNINGS: Only qualified technicians are allowed to work on pyrotechnic components. INHALED: Exposure to pyrotechnic residue may cause low blood pressure, severe headache, irritation of mucous membranes, fainting, shortness of breath or rapid pulse. Move a victim to fresh air. Seek immediate m

© 2011-2025 Copyright www.rrevoque.org