Range Rover Evoque: Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW
Windscreen VIN - China only
VIN label - UK, Europe and ROW
- Type/Approval Number - If shown
- VIN Number
- Gross Vehicle Weight
- Gross Trailer Weight
- Front Axle Weight
- Rear Axle Weight
- Colour Code Group
VIN label - China
- Vehicle VIN Number
- Engine Type/Capacity/Power
- Occupancy
- Build Date
- Gross Vehicle Weight
- Gross Trailer Weight
VIN label - Gulf markets
- Build Date
- Model year
- Vehicle VIN Number
Tire Data Label - UK, Europe and ROW
- Tire Size
- Tire Pressures
Certification/Tire data label - NAS only
- Vehicle VIN Number
- Bar Code Identification
- Tire Pressures
Tire pressure label - Canada only
- Tire Pressures
- Vehicle VIN Number
- Vehicle Type
VIN number identification
VIN number - UK, EU and ROW
VIN number - NAS and Canada
2.2 Liter Diesel Engine Serial Number
The 2.2 Liter Diesel Engine Serial Number is stamped on the RH side of the cylinder block.
2.0 Liter Petrol Engine Serial Number
The 2.0 Liter Petrol Engine Serial Number is etched into the RH side of the engine block.
Automatic Transmission Serial Number
The Automatic Transmission Serial Number is stamped on the LH side of the transmission casing.
Manual Transmission Serial Number
The Manual Transmission Serial Number is stamped on the transmission casing.
Rear Differential Serial Number
The Rear Differential Serial Number is stamped on the side of the differential casing.
Power transfer unit
The number is stamped on the underside of the casing.
READ NEXT:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Lifting
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
SEE MORE:
Direction indicator and side lamp bulbs
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it count
Headlamp Leveling Control Module (HLCM)
Headlamp Control Module (HCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the
