Range Rover Evoque: Replacing remote control batteries
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Heating and ventilation / Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.
READ NEXT:
Additional remote controls
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when
traction devices are fitted.
Never fit traction devices to a
temporary use spare wheel.
Land Ro
Radiator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
© 2011-2025 Copyright www.rrevoque.org
