Range Rover Evoque: Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit.

Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks.

the wheel Before raising the vehicle, the wheel diagonally opposite the one to be removed must be chocked.
Always chock the wheels using suitable wheel chocks. Place the chocks on both sides of the wheel diagonally opposite the wheel to be changed.
If jacking the vehicle on a slight slope is unavoidable, place the chocks on the downhill side of both wheels on the axle not being raised.

READ NEXT:

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure tha

 Locking wheel nuts

Locking wheel nuts can be removed only by using the special adapter provided in the tool kit. Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It shou

 Releasing locking wheel nuts

1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged. 2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.

SEE MORE:

 Cooling System Partial Draining, Filling and Bleeding

Draining CAUTIONS: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instruction may result in damage to the engine. Engine coolant will damage the paint finished surfaces. If

 Rear Wheelhouse Outer

Removal NOTES: It is necessary to remove the inner quarter panel to enable removal and installation of the rear wheelhouse outer. The rear wheelhouse outer is manufactured from mild steel. This method describes the LH rear wheelhouse outer, the RH side is similar. 1. The rear wheelhouse outer is

© 2011-2025 Copyright www.rrevoque.org