Range Rover Evoque: Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4.
5. CAUTION: Note the position of the component and mark the surrounding area to aid installation.
6. Remove the bushing.
Special Tool(s): LR-121, 204-620-02, 204-620-03
Installation
1. CAUTION: Make sure that the component is installed to the position noted on removal.
2. CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.
Install the bushing.
Special Tool(s): LR-121, 204-620-01, 204-620-02
3. Torque: 270 Nm
4. Torque: 110 Nm
5. Install the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
READ NEXT:
Rear Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspensi
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's i
SEE MORE:
Topping up the washer fluid
The washer reservoir supplies the front and
rear screen washer jets and headlamp washer
jets.
Check and top-up the reservoir level at least
every week. Always top-up with screen washer
fluid to prevent freezing.
Operate the washer switches periodically to
check that the nozzles are clear and
Front Seat Backrest Heater Mat
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
