Range Rover Evoque: Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
high temperature. Ensure that the
lamp units have cooled before
attempting to touch them.
Xenon lamp units contain Mercury
which is highly toxic and can be
extremely harmful.
Seek advice about the
correct
disposal of Xenon lamp units from a
Land Rover Dealer or your local
authority.
READ NEXT:
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove
Direction indicator and side lamp bulbs
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb hous
Rear lamp bulbs
1. Remove the two fixings.
2. Direction indicator.
3. Reversing lamp
Turn the relevant bulb holder counter
clockwise and pull to remove from the lamp
unit. Grip the holder then press the bulb i
SEE MORE:
Evaporator Temperature Sensor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installa
Topping up the brake/clutch fluid
Brake fluid will damage
painted
surfaces. Soak up any spillage with an
absorbent cloth immediately and wash
the area with a mixture of car shampoo
and water.
Only use new fluid from an airtight
container (fluid from open containers or
fluid previously bled from the system,
will have absor
© 2011-2025 Copyright www.rrevoque.org
