Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 Front Seat Recliner Motor

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 3. Refer to: Front Seat Co

 Changing the display

Changing the display Press the TRIP button on the end of the left column stalk repeatedly to display the trip data in the following order: - Date and odometer. - Trip distance. - Average speed. - Average fuel consumption. - Instantaneous fuel economy. - Range. - Blank. To reset the disp

© 2011-2025 Copyright www.rrevoque.org