Range Rover Evoque: Isofix child seat positions

Isofix child seat positions
Isofix child seat positions

- IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group.

- IL = These ISOFIX child restraint systems are of the specific vehicle, restricted or semi-universal categories.

- X = Not suitable for ISOFIX child restraint fitment in this mass group.

- * = Child seat suitable for use in these locations, is the Britax/Römer Baby Safe Plus

Note: Ages given are approximate. In case of doubt, the child’s weight, not age should be used when considering an appropriate child seat.

Note: The information contained in the table may not be applicable to all countries. If you are in any doubt regarding the type and fitment of child seats seek advice from your Dealer/ Authorised Repairer.

Note: ISOFIX anchorages are provided for second row outer seating positions. ISOFIX child restraints should be securely attached following the manufacturers instructions at these locations only.

READ NEXT:

 Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety. Follow t

 Installing an isofix child seat

Installing an isofix child seat To install an ISOFIX child seat: 1. Locate the ISOFIX locking mechanism. 2. Slide the child seat into the locking mechanism. 3. If an upper tether is fitted to t

 Tether anchorage points (Australia only)

WARNING: Child restraint anchorages are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, ha

SEE MORE:

 Speed Control

Speed Control Actuator Removal 1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation). Installation 1. To install, reverse the removal procedure. Speed Control Deactivator Switch Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTI

 Before programming

When programming a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure. For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other devic

© 2011-2025 Copyright www.rrevoque.org