Range Rover Evoque: Rear Door Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Torque: 1.3 Nm

Range Rover Evoque. Interior Trim and Ornamentation

2. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

3. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

4.

Range Rover Evoque. Interior Trim and Ornamentation

5.

Range Rover Evoque. Interior Trim and Ornamentation

6.

Range Rover Evoque. Interior Trim and Ornamentation

7. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

8. Torque: 0.6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

9.

Range Rover Evoque. Interior Trim and Ornamentation

10. Torque: 1 Nm

Range Rover Evoque. Interior Trim and Ornamentation

11.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

Liftgate Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. NOTE: Make sure the two metal clips are removed from the liftgate.

Range Rover Evoque. Interior Trim and Ornamentation

3. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Headliner

Removal NOTES: Removal steps in this procedure may contain installation details. Vehicles with glass roof panel shown, vehicles without glass roof panel similar. All vehicles 1. Refer to: Windshield

 Engine Cover GTDi 2.0L Petrol, Engine Cover TD4 2.2L Diesel

Engine Cover GTDi 2.0L Petrol Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Do not disassemble further if the component is removed for access only. Inst

 Loadspace Trim Panel

CAUTION: LH illustration shown, RH is similar. NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. 2. 3. 4. Torque: 1.4 Nm 5. Torque: 20 Nm 6. NOTE: LH side o

SEE MORE:

 Front Shock Absorber Vehicles Without: Dynamic Suspension

General Equipment Suspension Spring Compressor Vise Removal WARNINGS: Make sure the spring compressor Safe Working Load (SWL) meets or exceeds the spring rating quoted in the Specifcations section. Always follow the spring compressor manufacturer's instructions. The spring is under extreme te

 Deselecting valet mode

If Valet mode is active when you enter the vehicle, touch the Valet button to view the Valet mode screen. Enter your four digit PIN and touch the OK button. Valet mode is deactivated is displayed. - The tailgate will return to the previously set security requirement. - All touch screen funct

© 2011-2025 Copyright www.rrevoque.org