Range Rover Evoque: Steep slopes

If the vehicle is stationary on a steep, slippery slope, it may begin to slide even with the brakes applied. This is because without wheel rotation, the ABS cannot determine vehicle movement.

To counteract this, briefly release the brakes to allow some wheel rotation. Then re-apply the brakes to allow ABS to gain control.

READ NEXT:

 Emergency brake assist (EBA)

If the driver rapidly applies the brakes, EBA automatically boosts the braking force to its maximum, in order to bring the vehicle to a halt as quickly as possible. If the driver applies the brake

 Electronic brake distribution (EBD)

EBD controls the balance of braking forces supplied to the front and rear wheels, in order to maintain maximum braking efficiency. If the vehicle has a light load (only the driver in the vehicle f

 Electric parking brake (EPD)

The parking brake operates on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. Do not rely on the parking brake to operate effectiv

SEE MORE:

 Transfer Case Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 100-012 Slide Hammer 303-1300 Remover, Crankshaft Seal 303-538 Remover/Installer, Crankshaft Oil Seal 307-594 Installer, Seal 307-595 Installer, Intermediate Shaft Seal 308-615 Remover, Seals Removal NOTE: Some variation in the illustrations may occur, but the essential information

 Speed Control

Speed Control Actuator Removal 1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation). Installation 1. To install, reverse the removal procedure. Speed Control Deactivator Switch Removal NOTE: Removal steps in this procedure may contain installation details. 1. CAUTI

© 2011-2025 Copyright www.rrevoque.org