Range Rover Evoque: Towing
The rear sensors are automatically disabled when a trailer with an approved electrical connector is connected.
Note: Trailers fitted with LED lights will not disable the rear parking aids sensors. When reverse gear is selected, the attached trailer will be detected as an obstacle.
READ NEXT:
Cleaning the sensors
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampo
System fault
If a system fault is detected, a long
high-pitched tone will sound and the switch
indicator will flash. A message will be displayed
in the message centre. Contact your Dealer/
Authorised Repairer
Rear view camera
It remains the driver's
responsibility
to detect obstacles and estimate the
vehicle's distance from them when
reversing.
When Reverse (R) is selected the camera
provides a wide-angle rear view
SEE MORE:
Instrument Panel TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery,
Audio Amplifier Module (AAM)
CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the control module or a component is susp
© 2011-2025 Copyright www.rrevoque.org
