Range Rover Evoque: Using cruise control

Using cruise control
Using cruise control

1. Set target speed, or increase speed.

2. RES. Resume set speed.

3. CAN. Suspends cruise control operation without erasing memorised speed.

4. Decrease set speed.

Note: Cruise control is not available when using Hill Descent Control or when a Terrain Response special program has been selected.

Note: Do not use cruise control when driving off-road.

READ NEXT:

 Set or increase cruise speed

When setting the cruise control to the speed limit, it is important to remember that it is possible for the vehicle speed to increase when travelling downhill. This may result in the vehicle sp

 Decreasing cruise speed

To reduce cruising speed, press and hold control (4). Release the switch when the desired speed is reached, the new speed will be set and maintained. The set speed can be decreased in steps of 2k

 Suspending and resuming cruise control

Suspend cruise control with a single press of control (3). To resume cruise control at the previous set speed, press control (2). RES (2) should be used only if the driver is aware of the set

SEE MORE:

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation). 3.

© 2011-2025 Copyright www.rrevoque.org