Range Rover Evoque: Daytime running lamps

Daytime running lamps are LED lamps.

With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running.

- The gear selector is out of park (automatic transmission).

- The parking brake is not applied - market dependent.

Unless required or prohibited by law,

Unless required or prohibited by law, daytime running lamps can be disabled or enabled by your Dealer/Authorised Repairer.

READ NEXT:

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

 High beam assist

This feature of the Xenon lighting automatically selects and deselects high beam, under specific conditions of road lighting and in the absence of other vehicle’s lights. The system is only acti

 Auto lamps windscreen wiper detection

If Auto lamps is selected and the windscreen wipers are switched on for 20 seconds or more, the side lamps, tail lamps and headlamps will switch on automatically. When the wipers are switched off,

SEE MORE:

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the event of a collision. Do not drive or carry passengers with the head restraint removed from an

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; F = RF transmission; N = Medium speed CAN (controller area network) bus; O = LIN (local interconnect network) bus. Instrument cluster CJB (central junction box) Radio frequency (RF) receiver RFA (remote function actuator) / KVM (keyless vehicle module) Re

© 2011-2025 Copyright www.rrevoque.org