Range Rover Evoque: Direction indicator and side lamp bulbs
Removing the nearside bulbs;

To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
Removing the offside bulbs;

To gain more room for accessibility, follow the
process for moving the offside headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
READ NEXT:
1. Remove the two fixings.
2. Direction indicator.
3. Reversing lamp
Turn the relevant bulb holder counter
clockwise and pull to remove from the lamp
unit. Grip the holder then press the bulb i
Access to the rear fog lamp
requires
special tools and should be undertaken
only by a qualified technician. If in
doubt, consult your Land Rover
Dealer/Authorised Repairer.
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any compone
SEE MORE:
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting generator is located at the front of the engine on the
LH (left-hand) side of the cylinder block. There
© 2011-2025 Copyright www.rrevoque.org
