Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 A-Pillar Outer Panel

Removal NOTES: The A-pillar outer panel is manufactured from mild steel. The fender mounting bracket is serviced on the new panel. The upper and lower butt joint must be MIG brazed due to the location of a boron reinforcement. A new anti tamper VIN indentification decal will be required when rep

 Fuel Tank and Lines - Diagnosis and Testing

Principles of Operation For a detailed description of the fuel tank and lines systems, refer to the relevant Description and Operation section in the workshop manual. REFER to: (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol) Inspection and Verification WARNINGS: Eye protection must be worn at all

© 2011-2025 Copyright www.rrevoque.org