Range Rover Evoque: Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
2. Torque: 10 Nm
3. Torque: 80 Nm
Installation
1. To install, reverse the removal procedure.
Engine Lower Support Insulator
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. CAUTION: Discard the bolts.
4. CAUTION: Discard the bolt.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Only tighten the bolt finger-tight at this stage.
2. CAUTIONS:
Make sure that new bolts are installed.
Install all the bolts finger tight before final tightening.
Torque:
- Stage 1: 50 Nm
- Stage 2: 180
READ NEXT:
Oil Filter Housing
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essent
Engine - Diagnosis and Testing
Principles of Operation
For a detailed description of the engine system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)
SEE MORE:
Rear Lamp Mounting Panel
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles have vertical adjustment only.
Adjust the headlamps with an Allen Key.
Rotate the adjuster 'A' for
