Range Rover Evoque: Rear loadspace

travel in Never allow passengers to travel in the loadspace under any circumstances. All vehicle occupants should be seated correctly and wear a seat belt at all times when the vehicle is in motion.
Always ensure that objects carried within the vehicle are secured properly.

To remove the loadspace cover:

To remove the loadspace cover: 1. Release the two straps from the pins on the tailgate.

2. Pull the cover rearwards to release the retaining brackets on the edges of the cover from the pins on the loadspace side trim.

the Never place objects on top of the loadspace cover. During an accident or sudden manoeuvre, loose objects

Installation of the cover is the reverse of removal.

Storing the cover:

cover Do not store the loadspace cover loose in the vehicle.

1. Remove the loadspace cover.

2. Fold the rear seats forward.

3. Position the cover vertically in the vehicle approximately where the upright rear seat backrests are normally. The top surface of the cover must be facing forwards with the retaining brackets at the top.

4. Locate the retaining brackets onto the side trim pins.

5. Return the rear seats to the upright locked position.

READ NEXT:

 Roof racks

A loaded roof rack can reduce the stability of the vehicle, particularly when cornering and during cross winds. Driving off road with a loaded roof rack is not recommended. Fit only a roof ra

 Luggage anchor points

Luggage anchor points All items carried in the luggage area should be properly secured. 1. Bag hooks. - The bag hooks should only be used to secure light items such as shopping bags. 2. Lo

 Towing

SEE MORE:

 Brake/clutch fluid check

Seek qualified assistance immediately if brake pedal travel is unusually long or if there is any significant loss of brake fluid. Driving under such conditions could result in extended stopping distances or complete brake failure. Brake fluid is highly toxic - keep containers sealed and out

 Programming

Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver in the rear-view mirror, keeping the indicator lamp in

© 2011-2025 Copyright www.rrevoque.org