Range Rover Evoque: Replacement tyres

Do not fit tubed tyres. Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by Land Rover is unavoidable, ensure that you read and fully comply with the tyre manufacturer’s instructions.

Ideally, tyres should be replaced in sets of 4. If this is not possible, replace the tyres in pairs (both front or both rear). When tyres are replaced, the wheels should always be re-balanced and alignment checked.

READ NEXT:

 Tyre pressure compensation for low ambient temperature changes

A colder ambient local temperature will reduce pressure within the tyre. An effect is to decrease sidewall height and to increase tyre shoulder wear with the potential for tyre failure. Vehicle dy

 Tyre pressure compensation - high ambient temperatures

 Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the

SEE MORE:

 Wheel Knuckle Rear Bushing

Special Tool(s) 204-620-01 Installer, Wheel Knuckle Bushing 204-620-02 Remover/Installer, Wheel Knuckle Bushing 204-620-03 Remover, Wheel Knuckle Bushing LR-121 Hydraulic Cylinder 10t Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehicle, the wheel diagonally opposite the one to be removed must be chocked. Always chock the wheel

© 2011-2025 Copyright www.rrevoque.org