Range Rover Evoque: Single locking
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Exiting the vehicle / Single locking
Single locking secures the vehicle and prevents the doors from being opened from outside. The doors may still be unlocked and opened using the interior door locks and release levers. In this state, only the perimeter (exterior) alarm is activated. When the vehicle is Single locked and the alarm is armed, the alarm will sound if: - The bonnet, tailgate or a door is opened.
In some markets where a battery backed sounder is fitted the following actions will also sound the alarm: - The vehicle battery is disconnected.
- An attempt is made to disconnect the alarm siren.
Note: Single locking should be used in circumstances such as travelling on a ferry, if pets are to be left in the vehicle, or if a window must be left open.
READ NEXT:
Double locking
Never double lock the vehicle
with
people, children, or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quic
Mislock
When locking the vehicle with the Smart Key, if
one or more of the doors, the bonnet or the
tailgate is not fully closed, or the ignition is ON,
the vehicle will NOT lock and there will be an
audi
Global closing
Ensure that no children,
pets, or
obstructions are in any open aperture
before operating global closing.
Ensure that all doors are closed. Press and
hold the Smart Key lock button for 3 seconds
SEE MORE:
Four-Wheel Drive Systems
Four-Wheel Drive Systems - Component Location
NOTE: Automatic transmission shown, manual transmission similar
Transmission
Power transfer unit
Four-Wheel Drive Systems - Overview
OVERVIEW
The power transfer unit is located at the rear of the engine and is attached
directly to the transmission
Checking the tyre pressures
Tyre information label location.
Tyre pressures should be
checked
regularly using an accurate pressure
gauge, when the tyres are cold.
The following procedure should be used to
check and adjust the tyres pressures.
1. Remove the valve cap.
2. Firmly attach a tyre pressure gauge/inflator
© 2011-2025 Copyright www.rrevoque.org
