Range Rover Evoque: Urban cycle
The urban test cycle is carried out from a cold start and consists of a series of accelerations, decelerations and periods of steady speed driving and engine idling. The maximum speed attained during the test is 50km/h (30mph) with an average speed of 19km/h (12mph).
READ NEXT:
Extra-urban cycle
The extra-urban test cycle is carried out immediately after the urban test.
Approximately half of the
test comprises steady speed driving, while the remainder consists of a series of
acceleration
Combined
The combined figure is an average of the urban and extra-urban test cycle
results, which has been
weighted to take account of the different distances covered during the two
tests.
For additional
SEE MORE:
Drive Pinion Front Bearing
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation detail
© 2011-2025 Copyright www.rrevoque.org
