Range Rover Evoque: Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when
traction devices are fitted.
Never fit traction devices to a
temporary use spare wheel.
Land Rover approved traction devices may be used to improve traction on a hard road surface in heavy snow conditions. They should not be used in off-road conditions.
If it becomes necessary to fit traction devices, the following points must be observed: - Only Land Rover approved traction devices should be used on the vehicle. Only Land Rover approved traction devices have been tested to ensure that they do not cause damage to the vehicle. Contact your Land Rover Dealer/Authorised Repairer for information.
- The wheels and tyres fitted must conform to the specifications of the original equipment.
- Do not fit traction devices to 18, 19 or 20inch diameter wheels.
- Single sided Spike-spyder traction devices or snow chains can be fitted to only the front wheels of vehicles fitted with 17inch diameter wheels.
- Always read, understand and follow the traction device manufacturer's instructions.
- Avoid tyre/vehicle damage, by removing the traction devices as soon as the conditions allow.
READ NEXT:
Tpms inflation pressure compensation
If your vehicle is fitted with 18, 19 or 20 inch
wheels with TPMS, they can be replaced with
17 inch wheels with TPMS, so enabling the use
of snow chains or traction devices.
Tyre pressures of veh
Recovery
The method for recovery/ transportation of the
vehicle is on a transporter or trailer designed
for that purpose.
Ensure that transportation is carried out by
suitably qualified person and that the
SEE MORE:
Emergency brake assist (EBA)
If the driver rapidly applies the brakes, EBA
automatically boosts the braking force to its
maximum, in order to bring the vehicle to a halt
as quickly as possible. If the driver applies the
brakes slowly, but conditions mean that ABS
operates on the front wheels, EBA will increase
the braking
Front Inner Quarter Panel
Removal
NOTES:
The front inner quarter panel is manufactured from mild steel.
The front inner quarter panel is to be unpicked from the inner quarter panel, it
is not serviced separately.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components wi
