Range Rover Evoque: Direction indicator and side lamp bulbs
Removing the nearside bulbs;

To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
Removing the offside bulbs;

To gain more room for accessibility, follow the
process for moving the offside headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it counter clockwise to release.
READ NEXT:
1. Remove the two fixings.
2. Direction indicator.
3. Reversing lamp
Turn the relevant bulb holder counter
clockwise and pull to remove from the lamp
unit. Grip the holder then press the bulb i
Access to the rear fog lamp
requires
special tools and should be undertaken
only by a qualified technician. If in
doubt, consult your Land Rover
Dealer/Authorised Repairer.
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any compone
SEE MORE:
Under Bonnet View
1A - Brake/clutch fluid reservoir caps (beneath cover) left-hand drive (LHD)
vehicles.
1B - Brake/clutch fluid reservoir caps (beneath cover) right-hand drive
(RHD) vehicles.
2 - Engine oil filler cap.
3 - Oil level dipstick.
4 - Washer fluid filler cap.
5 - Engine cool
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
© 2011-2025 Copyright www.rrevoque.org
