Range Rover Evoque: How it works

Viewing angles for driver and front seat passenger are such that neither can view the full display that the other is viewing. However, there is an optimum viewing angle of 30 degrees where no cross over of images can be perceived. From this point, the closer to screen centre or screen side edges that the viewer moves to, the more likely cross over of images is. During normal use of dual view, image cross over is unlikely.

Rear seat passengers may be able to see both

Rear seat passengers may be able to see both views when dual view is active.

READ NEXT:

 Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia s

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

SEE MORE:

 Headlamp Adjustment

NOTE: The headlamp setting is 1.2 % below horizontal and parallel. 1. Align the headlamp beam setting equipment to one headlamp. 2. Switch the headlamps on and to dipped beam. 3. NOTE: NAS vehicles have vertical adjustment only. Adjust the headlamps with an Allen Key. Rotate the adjuster 'A' for

 Tyre change

Valve stem seal, washer, nut, valve core and cap should be replaced at every tyre change. Valve stem seal, washer and nut must be replaced if valve retention nut is loosened. Sensor units and nuts must be refitted using correct torque figures and associated profile. Damage to the vehicle m

© 2011-2025 Copyright www.rrevoque.org