Range Rover Evoque: Rear Lower Arm FWD
Removal
NOTES:
LH illustration shown, RH is similar.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. NOTE: All wheel drive transmission illustrations shown, front wheel drive transmission is similar.
4. CAUTION: Note the fitted position of the special washer.
5.
6.
7. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. NOTE: This step is only required if previously removed.
2. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
3. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
4. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Support weight of vehicle on a jack at the rear hub.
5.
6. Torque: 175 Nm
7. CAUTION: Note the fitted position of the special washer.
8. Torque: 175 Nm
9. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
10. Check and if necessary, adjust the rear wheel alignment
READ NEXT:
Rear Suspension FWD
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal li
Wheels and Tires
Wheel and Tire
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. NOTE: Ma
Vehicle Dynamic Suspension
Vehicle Dynamic Suspension - Component
Location
COMPONENT LOCATION
RH (right-hand) rear spring and damper assembly
RH rear height sensor
LH (left-hand) rear spring and damper assembly
LH rear he
SEE MORE:
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
Electric seats
Electric seats
1. Lumbar support adjustment.
2. Backrest adjustment.
3. Head restraint adjustment.
4. Height adjustment.
5. Forward and back adjustment.
6. Cushion angle adjustment.
To adjust the seats, the Smart Key must be
inside the vehicle.
Do not adjust
the seat while the
vehicle
