Range Rover Evoque: Kick-down
Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear changing will resume.
READ NEXT:
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
SEE MORE:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control arm
Subframe
Overview
The front suspension features long travel McPherson struts to optimize on a
Starting System - GTDi 2.0L Petrol
Starting System - Component
Location
COMPONENT LOCATION
Solenoid
12V supply from battery
Solenoid power supply from Battery Junction Box (BJB)
Starter motor
Pinion gear
Starting System - Overview
OVERVIEW
The starter motor is rated as 1.3 kW and is a Denso conventional design with
the motor
© 2011-2025 Copyright www.rrevoque.org
