Range Rover Evoque manuals

Range Rover Evoque: Oil Cooler

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).

4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L Petrol, General Procedures).

5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. CAUTION: Make sure that the area around the component is clean and free of foreign material.

READ NEXT:

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Timing Chain

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. 1. Refer to: Specifications

SEE MORE:

 Wipers and Washers - Removal and Installation

Windshield Wiper Motor Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and Installation). 2. NOTE: LHD illustration shown, RHD is similar. Torque: 8 Nm Installation 1. To install, reverse the removal proced

 Transmission TD4 2.2L Diesel - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

© 2011-2025 Copyright www.rrevoque.org