Range Rover Evoque: Rear wiper
If reverse gear is selected while the front wipers are operating, the rear wiper will start automatically and continue as long as reverse gear is selected. The wipe interval is dependent on the front wipers setting.
If reverse gear is selected while the rear wiper control is in the INT position, the wiper will operate for a single sweep of the rear screen.
When stationary, if the tailgate is opened while the rear wiper is operating, the wiper will stop.
When the tailgate is closed, the wiper will start to operate again after a delay of three seconds.
If the tailgate is open and vehicle speed is above 3km/h (2mph) the wiper will operate normally.
READ NEXT:
Wiper blade replacement
This subject is covered in the Maintenance
section. See 175, WIPER BLADE
REPLACEMENT.
Electric windows and panoramic roof blind
Electric windows and panoramic roof blind
1. Briefly pull a switch fully up and release,
the window will continue to rise until fully
closed. Briefly press a switch fully down
and release, the w
SEE MORE:
Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol,
Removal and Installation)
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starter motor
Generator
Transmission Control Module (TCM)
Cooling fan control module
Air Conditioning
© 2011-2025 Copyright www.rrevoque.org
