Range Rover Evoque: Steering Linkage
Tie Rod End
Special Tool(s)
205-754A
Splitter, Ball Joints
Removal
NOTE: RH illustration shown, LH is similar.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4. CAUTIONS:
Make sure that the ball joint ball does not rotate.
Discard the nut.
5. CAUTION: Make sure that the ball joint seal is not damaged. Special Tool(s): 205-754A
6.
7. CAUTION: Note the number of turns when removing the tie rod end to aid installation.
Installation
1. CAUTION: Make sure that the tie rod end is installed with the same number of turns as when removed.
2. WARNING: Make sure that a new nut is installed.
CAUTION: Make sure that the ball joint ball does not rotate. Torque: 133 Nm
3. Torque: 100 Nm
4. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
5. Using only four wheel alignment equipment approved by Land Rover, check and adjust the wheel alignment.
Steering Gear Boot
Removal
NOTE: LHD illustration shown, RHD is similar
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Tie Rod End (211-03 Steering Linkage, Removal and Installation).
3. NOTES:
Note the position of the components prior to removal.
Discard the retaining clips.
Installation
1. NOTES:
Make sure that these components are installed to the noted removal position.
Install new retaining clips.
2. Refer to: Tie Rod End (211-03 Steering Linkage, Removal and Installation).
Steering Linkage
Torque Specifications
* New nut must be installed
READ NEXT:
Steering Column
Steering Column - Component Location
Upper column
Steering wheel
Intermediate shaft
Steering Column - Overview
The steering column consists of an intermediate shaft, the upper column and
the st
Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identic
SEE MORE:
Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle m
Torque Converter Seal TD4 2.2L Diesel
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
