Range Rover Evoque: Lighting control
Lighting control
1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate.
Note: Do not use high beam where it may distract other road users.
2. Pull the control towards the steering wheel and release to flash the high beam on and off. The high beam will remain on for as long as the switch is held.
3. Sidelights.
4. Headlamps.
5. AUTO. With Auto lamps selected, when ambient light fades and the ignition is on, the side lamps, tail lamps, low beam headlamps and licence plate lamps will switch on automatically. Headlamp courtesy delay, High beam assist and Windscreen wipers detection may also be activated.
Note: Low exterior light levels, caused by adverse weather conditions, may also cause the autolamp system to activate.
6. Rear fog lamps. Will operate only while sidelights, headlamps or Auto lamps are selected. Turn the collar towards the steering wheel and release. The instrument pack warning lamp will illuminate.
7. Front fog lamps. Will operate only while sidelights, headlamps or Auto lamps are selected. Turn the collar away from the steering wheel and release.The instrument pack warning lamp will illuminate.
READ NEXT:
Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or
in AUTO position while lighting conditions do
not require headlamps on, then daytime
running lamps will switch
Headlamp courtesy delay
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
High beam assist
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
SEE MORE:
Parking Aid - Overview
OVERVIEW
The parking aid system provides an audible warning to the driver when any
obstacles are in the path of the vehicle during
forward or reverse parking maneuvers. The system consists of four ultrasonic
sensors in the front bumper and four
ultrasonic sensors in the rear bumper, a parking aid
Search area
The navigation map database is divided into
countries, or geographically defined areas
within countries, called search areas. When
setting a route, the destination (or waypoint)
entered must be in the currently selected
search area.
Before attempting to set a destination or
waypoint, set the
