Range Rover Evoque: Loadspace Trim Panel
CAUTION: LH illustration shown, RH is similar.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.

2.

3.

4. Torque: 1.4 Nm

5. Torque: 20 Nm

6. NOTE: LH side only.

7.

5-door
8.

9. CAUTION: Take extra care not to damage the
clips.
Release the lower retaining clips first and then the
upper retaining clips. Slide the trim panel forwards to
detach the trim panel.

3-door
10. CAUTION: Take extra care not to damage the
clips.

All vehicles
11. NOTE: If equipped.

12. NOTE: Do not disassemble further if the
component is removed for access only.

13. NOTE: LH side only.

14. NOTE: RH side only.

Installation
1. CAUTION: Take extra care not to damage the clips.
To install, reverse the removal procedure.
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4.
5. Torque: 6 Nm
6.
Installation
1. To install, reverse the removal procedure.
C-Pillar Lower Trim Pane
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Loadspace Trim Panel (501-05 Int
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
SEE MORE:
The powered tailgate may lose its position
memory if there are multiple object detections
or if battery voltage is low. Powered operation
may be inhibited. To reset the tailgate;
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open or to
the pre
Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by
Land Rover is unavoidable, ensure
that you read and fully comply with the
tyre manufacturer’s instructions.
Ideally, tyres should be replaced in sets of 4. If
© 2011-2025 Copyright www.rrevoque.org
