Range Rover Evoque: Rolling re-start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Rolling re-start
If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and then press the engine START/STOP button.
When the engine re-starts, select transmission position D.
Manual transmission - depress the clutch and then press the engine START/STOP button.
When the engine re-starts, select an appropriate forward gear.
READ NEXT:
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
SEE MORE:
Continuously Variable Damping Module (CVD)
Adaptive Damping Control Module (SUMB)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
© 2011-2025 Copyright www.rrevoque.org
