Range Rover Evoque: Settings - options
- If the Link DAB setting is switched on and the signal strength for a channel falls below an acceptable level, the audio unit will automatically search other available ensembles for a channel with the same name.
If an alternative local channel is found, the new channel is played automatically after few seconds. If the channel is not found after a few seconds, the message No reception is displayed.
The word Link is displayed at the top of the touch screen when Link DAB is enabled.
- Select DAB country if you drive into another country. Scroll through the country options to choose the appropriate one.
This will prompt an auto tune.
Note: This option is disabled while the vehicle is moving.
- Choose DAB format if you move to a region that uses a different digital band. Available formats are;
- L Band
- Band III
- L Band & Band III
- L Band Canada
- L Band Can & Band III
This will prompt an auto tune.
Note: This option is disabled while the vehicle is moving.
READ NEXT:
Digital radio reception
DAB radio can significantly increase the
number of radio channels/stations available.
The DAB signals are transmitted to most major
cities, towns and motorway networks.
Digital radio is transmitte
Ensembles
Unlike AM/FM radio, DAB transmits several
channels/stations on a single frequency. A
group of channels is known as an ensemble.
Some channels within the ensemble may have
subchannels offering seve
SEE MORE:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge on the cylinder block machined face.
Special Tool(s): 303-979
2. CAUTION: Make sure that the surfac
Intake Manifold
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specification
