Range Rover Evoque: Active On-Demand Coupling Vehicles With: AWF21 6-Speed Automatic Transmission
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
3. CAUTION: Make sure that the driveshaft is supported with suitable retaining straps.
4. CAUTIONS:
Mark the position of the driveshaft flange in relation to the drive pinion flange.
To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
5. NOTE: Use penetrating oil - spray through the driveshaft bolt holes as shown.
6. NOTE: Driveshaft joint shown removed for clarity.
7. NOTES:
Two washers must be installed to the assist in the removal of the driveshaft.
Alternate tighten the bolts until the movement of the driveshaft joint is detected.
8. CAUTION: Make sure that the driveshaft is supported with suitable retaining straps.
- Remove the bolts, turn the propshaft and repeat the above step at the other unthreaded hole.
- Repeat above steps until the driveshaft joint is fully released.
9.
10. CAUTION: Be prepared to collect escaping oil.
NOTE: Remove and discard the O-ring seal.
Installation
1. CAUTIONS:
Make sure that the area around the component is clean and free of foreign material.
Lubricate the O-ring seals.
Only use the specified material to lubricate the seals.
Torque: 24 Nm
2.
3. CAUTION: The component must be aligned with the installation markings. Torque: 40 Nm
4. Torque: 25 Nm
5. Check and top-up the active on-demand coupling fluid level.
Refer to: Active On-Demand Coupling Filling (205-02 Rear Drive Axle/Differential, General Procedures).
6. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L Diesel, Removal and Installation).
READ NEXT:
Active On-Demand Coupling Module
Removal
NOTE: If a new Active on-demand coupling module is installed, the throttle
valve must also be installed.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the v
Differential Case Vehicles With: AWF21
6-Speed Automatic Transmission
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove th
Differential Support Insulator
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Support the rear differential using a transmission jack.
3. CAUTION: Mark the components to aid
SEE MORE:
Topping up the washer fluid
The washer reservoir supplies the front and
rear screen washer jets and headlamp washer
jets.
Check and top-up the reservoir level at least
every week. Always top-up with screen washer
fluid to prevent freezing.
Operate the washer switches periodically to
check that the nozzles are clear and
Touch screen overview
Note: Physical controls are referred to as hard
keys. Virtual buttons on the touch screen are
referred to as soft keys.
Screen options will vary depending on vehicle
specification and set-up.
Touch screen overview
1. Screen on/off. The first use after switching
the ignition on will display
