Range Rover Evoque: Front Lower Arm

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Rear Suspension / Front Lower Arm

Removal

NOTES:

Some variation in the illustrations may occur, but the essential information is always correct.

Front wheel drive transmission illustrations shown, all wheel wheel drive transmission is similar.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

3.

Range Rover Evoque. Rear Suspension

4.

Range Rover Evoque. Rear Suspension

Installation

1. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

2. CAUTION: Only tighten the nut and bolt finger tight at this stage.

Range Rover Evoque. Rear Suspension

3. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

Support weight of vehicle on a jack at the rear hub.

4. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

5. Torque: 175 Nm

Range Rover Evoque. Rear Suspension

6. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

READ NEXT:

Rear Lower Arm AWD

Special Tool(s) 205-857 Remover, Halfshaft Removal CAUTION: LH illustration shown, RH is similar. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Rear Stabilizer Bar

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure

Wheel Knuckle

Special Tool(s) 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshaf

SEE MORE:

Diesel misfuelling protection device

When the misfuelling device is activated, it may cause fuel to be discharged from the filler neck. Note: It is the driver’s responsibility to fill the vehicle with the correct fuel. The diesel misfuelling protection device only reduces the risk of filling the vehicle with the incorrect fuel

Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

© 2011-2025 Copyright www.rrevoque.org