Range Rover Evoque: Mirror dip when reversing
If the vehicle is equipped with memory seats, when reverse gear is selected the door mirrors can be set to automatically adjust, providing an improved viewing angle of the curb side for reversing. The Reverse-dip mirror feature must be switched on. See 56, VEHICLE INFORMATION AND SETTINGS MENU.
The exact dipped position can be adjusted while the mirrors are dipped; 1. With the ignition on, select reverse gear.
2. With the mirror adjust controls, adjust to the desired dip position.
3. Select neutral (N) gear. This will store your setting for future use.
The next time reverse is selected, the newly adjusted position will be selected.
When the gear selector is moved out of reverse, the mirrors will return to their previous position.
Note: If vehicle speed exceeds 7km/h (4mph) in reverse, the mirrors will return to their normal driving position for enhanced visibility.
READ NEXT:
Interior mirror
Auto dimming mirror
1. Ambient light sensor.
2. High beam assist sensor.
Interior mirror dimming will adjust
automatically according to the amount of
ambient light when the ignition is on. If r
Blind spot monitor
The Blind
Spot Monitor (BSM) system
is a supplement to, not a replacement
for, a safe driving style and use of the
exterior and rear-view mirrors.
Please note that BSM may not be able
to give
SEE MORE:
Crankshaft Position (CKP)
Sensor
Special Tool(s)
303-1390A
CKP Sensor Alignment Tool
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire
Transmission Vehicles With: M66 6-Speed
Manual Transmission FWD - Installation
Installation
Special Tool(s)
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously
removed.
2. NOTE: This step is only
