Range Rover Evoque: Pairing and connecting from the touch screen
1. Switch on your mobile phone’s Bluetooth® connection. Make sure that your mobile phone is in Bluetooth® discoverable mode, sometimes referred to as find me mode (see your phone’s operating instructions for more information).
2. Switch the ignition on and ensure that the touch screen is active.
3. From the home menu select Phone.
4. A menu will appear. Select Search new.
5. Select Vehicle to device option.
6. Identify your phone from the displayed list and select the corresponding Pair and connect option.
Note: If more than 5 devices are detected, it may be necessary to use the scroll bar to see the entire list.
7. When prompted, enter the PIN code into your phone. See your phone’s operating instructions for further information.
8. Once your phone is paired and connected to the system, a confirmation message will be displayed before switching to the Digit Dial screen.
Note: Due to the duration of a Bluetooth®
search, it is advised that the timeout to home
screen feature is switched off before
attempting to search for Bluetooth® devices.
This setting can be changed within Vehicle,
Syst settings, Display set, Timeout to home
screen.
READ NEXT:
Changing the connected phone
Up to 10 mobile phones can be paired with the
vehicle in the same way. However, only one can
be connected and ready for use as a phone at
any one time.
To connect a different paired phone, follow
Touch screen icons
Connect. Use to send or accept
a call and access last 10 dialled
numbers.
Disconnect. Use to end or reject
a call.
No phone connected.
Phone signal strength indicator.
Phone battery l
Steering wheel icons
Connect. Press and release to
send or accept a call or to
access the last 10 dialled list.
Press and hold to access the
phonebook.
Disconnect. Use to end or reject
a call.
Voice control t
SEE MORE:
Side Air Bag Module Vehicles With: Sports
Seats
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
components. To deplete the backup power supply
energy, disconnect the battery ground cable and wait
General program (special programs off)
This program is compatible with all
on and off-road conditions. If not
already active, it should be selected
before driving on surfaces which are similar to
a hard road surface. Dry cobbles, tarmac, dry
wooden planks, etc., all fall into this category.
This program should be selected once th
