Range Rover Evoque: Rain sensor/speed sensitive wiper control
Intermittent operation of the wipers is
controlled initially by either vehicle speed or a
rain sensor located at the upper edge of the
windscreen. Both methods of control will clear
the screens adequately. Vehicle speed control
is set by the user and control via a rain sensor
is automatic.
This function can be
enabled/disabled
by your Dealer/Authorised Repairer.
READ NEXT:
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain senso
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph),
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled
SEE MORE:
Component Location
COMPONENT LOCATION SHEET 1 OF 2
Battery
ECM (engine control module)
CJB (central junction box)
Passenger air bag
Overhead console
RCM (restraints control module)
Driver air bag
Driver lower air bag
Clockspring
Adaptive steering column
BJB (battery junction box)
COMPO
Component Location
NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive)
installations similar.
COMPONENT LOCATION - SHEET 1 OF 2
RH (right-hand) front wheel speed sensor
RH rear wheel speed sensor
LH (left-hand) rear wheel speed sensor
LH front wheel speed sensor
Integrate
© 2011-2025 Copyright www.rrevoque.org
