Range Rover Evoque: Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage door opener receiver (motor
head unit) in the garage, locate the learn or
smart button/switch.
- The name of the button or switch may
vary between manufacturers.
2. Press and release the learn or smart
button.
3. In your vehicle, firmly press the previously
programmed HomeLink opener button
twice and release.
4. Press and hold briefly to complete the
programming process.
HomeLink should now activate the rolling code
device.
READ NEXT:
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
SEE MORE:
Contacts stored in the memory of a paired
phone can be automatically downloaded to the
vehicle’s phonebook each time the phone is
connected to the system. See 141,
TELEPHONE COMPATIBILITY.
Certain mobile phones store the phonebook in
two different areas, the SIM card and the phone
memory. T
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehicle,
the wheel
diagonally opposite the one to be
removed must be chocked.
Always chock the wheel
© 2011-2025 Copyright www.rrevoque.org
