Range Rover Evoque: Selecting valet mode
Valet mode allows the vehicle to be driven, e.g.,
by a parking attendant, but leaves the tailgate
locked and restricts use of the touch screen.
This prevents access to telephone numbers,
navigation addresses and audio system
settings.
From the Home menu, select Valet:
Enter a four digit Personal identification
Number (PIN) (personally chosen). On
completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
After entering the PIN, you will be prompted to
enter the PIN again. Enter the same PIN and
touch OK to confirm.
A pop-up screen is displayed, confirming your
vehicle is now in Valet mode.
READ NEXT:
The interior protection feature of the full alarm
system may be temporarily disabled via Alarm
sensors in the Vehicle Settings menu. See 56,
VEHICLE INFORMATION AND SETTINGS
MENU.
Note: If the in
In certain markets, a battery backed sounder is
fitted. This device will sound if it or the vehicle
battery is disconnected while the security
system is armed.
The tilt sensor detects any change to the
vehicle’s angle to the ground. When the alarm
is armed and the vehicle is double locked, any
change in the vehicle’s angle will activate the
tilt alar
SEE MORE:
Special Tool(s)
303-1300
Remover, Crankshaft Seal
303-882
Installer, Halfshaft Seal
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front
Drive Halfshafts, Removal and Installation).
3. CA
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery
© 2011-2026 Copyright www.rrevoque.org - 0.0047
