Range Rover Evoque: Stalled adjustment

movement stops unexpectedly If seat movement stops unexpectedly during adjustment check for any obstructions and remove.

Once any obstructions have been removed the seat adjustment mechanism can be reset as follows.

Operate the button again to continue the stalled adjustment. When seat movement resumes hold the button until the end of travel in that direction has been reached. The seat position can now be carried out as normal.

Note: If no obstructions can be seen, but normal adjustment cannot be carried out without stalling, contact your Land Rover Dealer/Approved Repairer.

READ NEXT:

 Sitting in the correct position

The driver and front seat passenger must not ride with the seat fully reclined. Do not adjust the seat while the vehicle is moving. The seat, head restraint, seat belt and airbags, all con

 Memory seats

Front seat positions can be saved to vehicle memory. Once you have adjusted the power operated driver’s seat and the exterior mirrors, the vehicle can memorise the settings for future use. See

 Easy entry/exit

When Easy entry/exit is configured, the driver’s seat will automatically lower when the ignition is switched off and the door release lever is used. Upon returning to the vehicle, when the drive

SEE MORE:

  Power Flows

Operation of the transmission is controlled by the TCM which electrically activates various solenoids to control the transmission gear selection. The sequence of solenoid activation is based on programmed information in the TCM memory and physical transmission operating conditions such as vehicle

  Transmission Control Module (TCM), Gear Shift Module (GSM)

TRANSMISSION CONTROL MODULE (TCM) TCM Neutral 'N' position Park 'P' position Position sensor/manual shaft Electrical connector The TCM is located on the top of the transmission casing and is connected on the high speed CAN (controller area network) bus to send and receive information to and

© 2011-2026 Copyright www.rrevoque.org - 0.0064