Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Rear Quarter Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation). 2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). 3. 4. 5. 6. CAUTION: Discard the bolt.

 Battery - Diagnosis and Testing

Principles of Operation For a detailed description of the battery system and operation, refer to the relevant Description and Operation section of the workshop manual. REFER to: (414-01 Battery, Mounting and Cables) Inspection and Verification CAUTION: Diagnosis by substitution from a donor vehicle

© 2011-2025 Copyright www.rrevoque.org