Range Rover Evoque: Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
2. Torque: 10 Nm
3. Torque: 80 Nm
Installation
1. To install, reverse the removal procedure.
Engine Lower Support Insulator
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).
3. CAUTION: Discard the bolts.
4. CAUTION: Discard the bolt.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Only tighten the bolt finger-tight at this stage.
2. CAUTIONS:
Make sure that new bolts are installed.
Install all the bolts finger tight before final tightening.
Torque:
- Stage 1: 50 Nm
- Stage 2: 180
READ NEXT:
Oil Filter Housing
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Balance Shaft Assembly
Special Tool(s)
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essent
Engine - Diagnosis and Testing
Principles of Operation
For a detailed description of the engine system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-01B Engine - GTDi 2.0L Petrol)
SEE MORE:
Charging or replacing the vehicle battery
If the vehicle battery should require charging,
the battery must be removed from the vehicle.
Consult your Dealer/Authorised Repairer.
Battery disconnection,
removal and
replacement should be carried out only
by qualified personnel. Consult your
Dealer/Authorised Repairer.
Used batteries
Spare Wheel Well
Removal
NOTES:
The spare wheel well is manufactured from mild steel, it includes the
spare wheel retaining bracket.
The panel is serviced less its weld studs
1. The spare wheel well is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
Rear bumper mounting LH & RH
Rea
