Range Rover Evoque: Epb automatic use
EPB will be applied automatically if the ignition is switched off and the vehicle speed is below 3km/h (2mph).
To prevent automatic operation, when the vehicle is stationary, press and hold the EPB switch in the release position. Within 5 seconds, switch off the ignition and continue to hold the EPB switch for a further 2 seconds.
EPB release - manual transmission:
If the vehicle is stationary with the EPB applied, pressing the accelerator and releasing the clutch will release the EPB and allow the vehicle to move off.
Automatic release will operate in first, second and reverse gears.
To delay automatic release, hold the EPB lever in the applied position, and release at the desired point.
The parking brake system gradually reduces the system load to assist a smooth drive away.
If the reduction in system load causes the vehicle to move after a valid gear is selected, full load will be automatically re-applied to the parking brake.
To override the load reducing feature of the EPB, manually apply the parking brake after selecting a gear.
In the event of a failure, a PARKBRAKE message will be displayed in the message centre.
EPB release - automatic transmission:
If the vehicle is stationary with the EPB applied and the transmission in D or R, pressing the accelerator will release the EPB and allow the vehicle to move off.
Note: Automatic release of the EPB is possible only when the driver’s door is closed and the driver’s seat belt is buckled.
To delay automatic release, hold the EPB lever in the applied position and release at the desired point.
The parking brake system gradually reduces the system load to assist a smooth drive away.
If the reduction in system load causes the vehicle to move after a valid gear is selected, full load will be automatically re-applied to the parking brake.
To override the load reducing feature of the EPB, manually apply the parking brake after selecting a gear.
In the event of a failure, a PARKBRAKE message will be displayed in the message centre.
At the start of a journey, EPB release times may be extended when changing from P or N. This is to allow for increased gear engagement times.
READ NEXT:
Epb warning indicators
If the system detects a fault with the EPB, the
amber brake warning indicator will illuminate
accompanied by a message on the message
centre.
If the system detects a fault while EPB is
operating,
Using cruise control
Using cruise control
1. Set target speed, or increase speed.
2. RES. Resume set speed.
3. CAN. Suspends cruise control operation
without erasing memorised speed.
4. Decrease set speed.
Note: C
SEE MORE:
Digital radio reception
DAB radio can significantly increase the
number of radio channels/stations available.
The DAB signals are transmitted to most major
cities, towns and motorway networks.
Digital radio is transmitted from regional
transmitters. Some local channels are not
available outside the range of their
tr
Rds-tmc display
When a TMC signal is received the icon in the
top left of the screen will appear green. If a TMC
signal is not being received, the icon will be
shown with a bar through it.
The system will inform the driver of any
reported roadworks, narrow road, contraflow,
accidents, slippery road, diversion
